The front load washer features a door switch that is actually a safety feature.
Whirlpool direct drive front load washer won t unlock.
Door won t unlock making buzzing noise.
You ll notice that it isn t pulling it far enough to allow the door to open.
The only thing you can.
My whirlpool duet won t unlock step 1.
Look inside the washer.
Go ahead and inspect the door striker to ensure it s engaging properly with the lock assembly.
Whirlpool washer front load direct drive.
Unplug your washer from the wall outlet if none of the these steps unlocks the door.
You can manually unlock the washer by removing the top remove screws on the back of the top panel and slide the top panel back to lift off.
On most whirlpool models the door must be closed and locked before any wash cycle will begin.
Washers dryers washers explore washers.
You may find a clog or restriction in this area that has been preventing the washer from draining.
The washer will reset and this could cause the door to unlock.
Then with the washer unplugged reach down and pull a small ring on the top of the door lock to manually open the door lock.
Explore front load laundry set laundry parts accessories smart laundry appliances kitchen appliances refrigerators.
Tried unplugging to see if that answered by a verified appliance technician.
Unplug the washer or trip the circuit breaker.
If your whirlpool washer did not unlock at the end of step 1 press and hold the end of cycle button for five seconds to manually reset your washing machine.
You can manually unlock the washer by removing the top remove screws on the back of the top panel and slide the top panel back to lift off.
Pull the opening handle out fully and you ll see there s a paddle behind it that pulls back the metal latch.
Avoid trying to force the door open by pulling on it or by using tools to pry it open.
These switches are generally located on the washer s door frame.
Then with the washer unplugged reach down and pull a small ring on the top of the door lock to manually open the door lock.
After 45 minutes plug your washer back in.
If unplugging the washer did not unlock the door then you can unplug the washer and remove the bottom front service panel as shown below.
Arrange a shallow pan under the pump filter and remove it to drain any water remaining in the washer.
